Image,Krull
  • Image,Krull

Krull



  • £ 2.99

High Quality Minature Monsters are printed in Resin.

These are usually better detailed than that of their FILAMENT counterparts and they are considerably heaver.

When printing with a RESIN printer, supports are required as the model is printed upside down. Without supports the model would otherwise fall off the printing plate.

After printing your model we will trim off the supports and then place the model in a cleaning machine. Once cleaned we will place the model into a curing machine to cure the model. Curing the model is required as it would otherwise remain slimy and sticky forever.

You can have your model printed in one of eight colours, models are supplied with a base. If you would like your base printed in a different Resin colour just advise us of that during the checkout process in the Any Notes section.

NOTE (Before Painting)

You may want to sand your model if any support points remain visible.

If you want to paint your model, we would suggest that you get your model printed in grey resin and then use that as a primer for other colours to be applied on top.

Newsletter Signup